Hi All,
I have a report which is based on the two flows i.e. FI and SD.
In SD, the data flows from 2LIS_13_VDITM à DSO 1 à DSO 2
Now, in the transformation from DSO1 à DSO 2, there is a start routine in which a look up is done on 0FIAR_O03 DSO and the FI document status is updated in the SD flow (along with some other fields from FI) based on the condition that accounting doc from FI is same as the Billing doc in SD.
Suppose that the FI document status changes from Open to Close, then this change will be captured in the FI flow and the delta will be loaded in the DSO 0FIAR_O03. But, in the SD flow, this change will not be captured in the delta and hence I have to do a full load every time from DSO1 to DSO2 in the SD flow to update the correct FI document status. This full load takes around 5 hours (data loading and activation in the DSO2) daily. I want to avoid the full loads to reduce the data loading time.
Is there any better way to do this? Please let me know your inputs.
Thanks in advance.
Regards,
Nitin.